Good day,We have an issue with some users that are not having internet
access because authentication is not working properly. On the Fortigate
or Analyzer i can see the log on for a specific user but the user is not
matching any rule for thus being b...
Good day The client is experiencing issues when switching between LAN
and wireless via FSSO. Seems as if firewall is not refreshing/updating
this correctly.When user switches off wifi moving to lan ip address the
fsso entry on the firewall is not upd...
For some reason users get kicked out after 16:00 GMT +2. Has anybody
experienced something simillar FSSO is running in polling mode and the
client has 7 DCs. Please assist
Hello I have two WAN links and have inbound policies for mail for
redundancy I would like to route traffic back SMTP traffic out the
interface it came in on. The problem is when both links are up at times
traffic goes out through the other link inste...
Hi all, I am doing a conversion of a Juniper firewall to a Fortigate and
I have a problem configuring iBGP and eBGP on the same VDOM whereby the
Fortigare will be configured with two different local as 65000 and 64999
Only one as is configurable
As per the Fortinet doc I set the deantry interval to 0 but I have found
that those users were also on NTLM authentication it looks like if I get
this out then I will have won.
Hi there, If you have as little as FAZ 200D you will be licenced for 150
Fortinet devices/VDOMs/ADOMs. See below for the product matrix
https://www.fortinet.com/...net_Product_Matrix.pdf
Hi there, I don't think there is need to worry much here since they are
all FGT 100Ds since the firmware is the same for the same devices (note
i am not sure the significant difference between G2 and G3) but the only
diffrence that matters in convers...
Hi There, If you disconnect one link and there is no traffic then it
means there is definitely a misconfiguration. First make sure you each
link works perfect on its own. Thanks and Regards C
