Anyone have any experience when setting up standard vswitch from ESX to
FortiSwitches standalone? FSW2 - FSW3 are setup with mclag-icl ESX host
have a connection to each on same port number, with trunk mclag enabled.
trunk set to static as instructed...
Just a update on this. Appears that routing is not supported on MCLAG.
Looks like all routing (static and dynamic). After changing the routing
to point to a FGT and making sure the static routes are on there,
everything started working.
It would probably be mclag. I found the below to be very useful when I
had to configure the 4 x 1048e's and 2 x 548d's!
https://help.fortinet.com/fos60hlp/60/Content/FortiOS/fortigate-managing-fortiswitch/Stacking.htm
set bundle {enable | disable} Enable/disable Link Aggregation Group
(LAG) bundling for non-FortiLink interfaces.
https://help.fortinet.com/cli/fos50hlp/56/Content/FortiOS/fortiOS-cli-ref-56/config/switch-controller/managed-switch.htm
