We have a fortigate 310 B v4.0 MR3 Build 12. We have a substantial
number of Firewall Objects , Address and groups. Can this information be
easily exported and imported into a Fortigate 240 D v5.0 GA Patch 5?
Thanks Niall
Hello, We are using 2 X Fortigate 310 B V4.0 MR1 in a site to site
/point to point configuration. We have a IPSec VPN between both devices
but we are gettting a very poor throughput speed between both devices
over the vpn. The point to point connecti...
thats great. Thanks very much. I tried that and it seems to have worked.
It did say Failure when I tired to import it but when i go to objects I
see them all listed so it looks ok. Thanks again.
Thanks Guys, So do I not need to follow the scenario
guidlelines..ie....for a policy based IPsec do the following?
Accelerated policy-based VPN configuration To configure FortiGate_1 1.
Go to VPN > IPsec > Auto Key (IKE) and select Create Phase 1. 2....
Thanks for the quick response. Ok it looks like you are right. I
inherited this device so I didnt do the original config. It looks like I
will have to recreate the Phase 1 as the existing Phase 1 does not allow
me to specify a local gw in order to co...
Thanks for the Post Romanr Yes I believe we are using teh NP2
acceleration - the ports in use are NP2 powered ports. I will check the
manual again.Below is output from that command: #diagnose vpn ipsec
status All ipsec crypto devices in use: NP2-0 nu...
Actually, sorry for confusion we have allowed for jumbo frames with an
mtu of 9216 on the switch ports which the Forinet is connected to. Is
there any that needs to be done on the Fortinet to allow for this?
Thanks, Niall
