Fortinet Community

scheehan_FTNT · 05-04-2022

Description This article describes Persistence rule influence Load-Balance Weight decision. Scope FortiADC v6.0 and later. Solution Assigns relative preference among members—higher values are more preferred and are assigned connections more frequentl...

scheehan_FTNT · 03-22-2022

Description This article describes the WAF URL protection rule in FortiADC to perform allow and deny action based upon a specific pattern. Scope v6.2 and later Solution Example scenario: 1. www.abc.com/about.hml < --- action Deny 2.www.xyz.com/about....

scheehan_FTNT · 10-04-2021

DescriptionThis article explains and provides configuration example pertaining on HA management interface setup.Typical example of HA Active-Passive setup with HA reserved management interface setup. For more information about how to configure HA res...

scheehan_FTNT · 09-19-2021

DescriptionThis article describes how to add WL-Proxy-SSL HTTP header to meet case requirement below.Based on Oracle WebLogic documentation indicates, with proxy-ssl deployment setup in-front of WebLogic server, it requires to have WLProxySSL paramet...

scheehan_FTNT · 09-10-2021

DescriptionThis article highlights known issue pertaining to alert email 'From' field.ScopeFor version 6.1.1.SolutionEmail header field 'From' is missing. From version 6.1.3, email header field 'From' has been reinstated.

scheehan_FTNT · 10-19-2015

Hi May be below KB is what you need How internal users can access internal resources via an external VIP (public IP address):-http://kb.fortinet.com/kb/microsites/search.do?cmd=displayKC&docType=kc&externalId=FD33976 How to access natted server inter...

scheehan_FTNT · 03-14-2015

Hi, It would be helpful if you provide session info. Please remove/replace any sensitive info like public IP address # diag sys session filter dport 3389# diag sys session li

scheehan_FTNT · 03-08-2015

Hi, - You need to configure web server infoconfig system server-probe edit 1 set server "X.X.X.X" set srcintf "port1" set protocol http-get set url www.mywebserver.com next end - You can verify with below diag command# diag sys server-probe status al...

scheehan_FTNT · 02-11-2015

Hi, Alert message itself "Permission Denied" is telling you it [FGT] can't locate any "matching" authentication info you have provided.I assume this is sslvpn web mode accessdid you check the vpn log entries in regards to these "Permission Denied" ac...

Fortinet Community

User Statistics

User Activity

Technical Tip: Load-balance weight and persistence rule notion

Technical Tip: WAF URL Protection Pattern Matching

Technical Tip: HA management interface connectivity setup for Active-Passive mode

Technical Tip: How to add WL-proxy-SSL HTTP header for WebLogic server with SSL-Offloading setup

Technical Tip: Alert email 'From' missing field

Re: Unable to reach VIP interface from internal

Re: Virtual IP source address

Re: probe-response

Re: 2 ISP's 2 SSL VPN

Fortinet Training Institute