Re: Legacy FortiGate 100A

Sandeep_FTNT · 11-14-2019

DescriptionAgentless NTLM authentication can be configured directly from the FortiGate to the Domain Controller using the SMB protocol (no agent is required). This authentication method is only supported for proxy policies. The set domain-controller ...

Sandeep_FTNT · 11-14-2019

DescriptionCustom VM might fail to activate if custom VM is not configured properly or does not meet the requirements. This article provides check list to investigate it. Solution-Run Virtual box and check the following settings:Make sure Network 'ad...

Sandeep_FTNT · 11-14-2019

Description This article describes how to configure and troubleshoot an FTP proxy on FortiGate. Scope FortiGate.Solution The FortiGate FTP explicit feature enables explicit FTP proxying of IPv4 and IPV6 traffic on one or more FortiGate interfaces.To ...

Sandeep_FTNT · 04-24-2015

Description This article describes that multicast forwarding is used to forward multicast packets between multicast routers and receivers, enabling efficient distribution of data to multiple recipients simultaneously. Applications and services that i...

Sandeep_FTNT · 10-14-2014

Description This article describes how to keep a WiFi network on the same subnet as a LAN or desired VLAN network. This is important as a FortiGate unit requires each network interface to have a single unique network segment. Scope FortiGate. Solutio...

Sandeep_FTNT · 10-04-2015

Hi Kyza, Here I understand that you dont have control on landlords router but yet router needs to allow VPN traffic to fortigate 30D so on router you need to configure port forwarding ( VPN ports UDP 500 and UDP 4500) to send VPN traffic to 30D Forti...

Sandeep_FTNT · 10-04-2015

You can try to find out all ports that skype uses and then create a policy route for the same via wan2 however skype also uses web ports (80 and 443) so policy route will also get applied to http/s traffic .

Sandeep_FTNT · 07-01-2015

Static route on sonicwall should be like belowDestination: 172.16.0.0/22Gateway - 192.168.101.25

Sandeep_FTNT · 07-01-2015

On fortigate you simply create a firewall policy from LAN to WAN without NAT enabled in it , which is essentially route mode . On sonicwall create a static route for 172.16.0.0/22 subnet with gateway as IP address WAN interface of fortigate .

Sandeep_FTNT · 06-30-2015

Its running on version 3 MR2 firmware . You can upgrade the device to firmware version 4 MR3 patch 18 which is latest firmware for this appliance model . This appliance model cant be upgraded to version 5 . You can follow the upgrade path on below be...

User Statistics

User Activity

Technical Tip: Agentless NTLM Authentication for proxy

Technical Tip: Checklist to investigate why custom VM failed to activate

Technical Tip: Configure and troubleshoot an FTP proxy

Technical Note: Forwarding multicast traffic in NAT mode

Technical Tip: How to bridge a FortiGate WiFi network to a wired network or VLAN network

Re: Site-to-site IPsec vpn tunnel behind a NAT router

Re: forcing outbound traffic of an application on wan2

Re: Getting private range on Wan dont want to double nat

Re: Getting private range on Wan dont want to double nat

Re: Legacy FortiGate 100A

Re: Legacy FortiGate 100A

Re: Can't connect 221C with 60D

Fortinet Training Institute

KCS