Description This article discusses FortiGate-VM probe traffic behavior
when VIP is enabled. Scope FortiGate-VM. Solution In the Azure or AWS
load balancer, if the FortiGate-VM probe is enabled, the Azure or AWS
load balancer sends out a probe to a TC...
Description This article describes how to disable the ip-address rating
in Web-proxy policy. Scope FortiGate and FortiProxy. Solution When the
URL category is used as the destination address in a web-proxy policy,
there is no possibility to apply the...
Description This article describes the External Threat connector
behavior when High Availablity. Scope FortiGate. Solution When the
External Threat connector is configured in High Availability, the
primary unit has access to the resource's primary st...
Description This article describes how to prevent the 'Tunnel to
fortimanager is down' error from appearing in event logs when
FortiManager is not configured. Scope FortiGate. Solution In this
example, the FortiCloud status is enabled and central man...
Description This article describes how to monitor disk usage with SNMP
OIDs. Scope FortiGate. Solution The following OIDs are used to monitor
disk usage with SNMP OIDs.
FORTINET-FORTIGATE-MIB:fortinet.fnFortiGateMib.fgSystem.fgSystemInfo.fgSysDiskUsa...
Hi Kindly follow the below article for your reqiremnet.
https://community.fortinet.com/t5/FortiGate/Technical-Tip-Implement-Source-NAT-for-IPsec-interface/ta-p/224533
-
Hi, The vdom link will be synced between the cluster members. so primary
and secondary have the same IP address for the vdom link. So kindly
check the reason the the delay in connectivity after failover.
https://community.fortinet.com/t5/FortiGate/Tr...
Dear Customer, It can be possible from iprope cache, kindly run "
diagnose firewall iprope list" check the cache then iprope cache clear
the " diagnose firewall iprope clear" then " diagnose firewall iprope
list". -Habeeb
Hi, To create a report for network device reboots and log stoppages in
FortiSIEM, follow these steps: 1. Access the FortiSIEM interface.2.
Navigate to the Reports section.3. Select "Create Report" to define a
new report.4. Choose the appropriate repo...
Hi Hakem, Create a web server and store the hash values in a text file.
Next, configure the FortiGate by doing as instructed in the following
article:
https://docs.fortinet.com/document/fortigate/6.2.0/new-features/628165/external-block-list-threat-f...