Hi, We have a number of Fortigate firewalls which have multiple public
WAN interfaces for primary and secondary circuit. The Fortigate also
have VPN tunnels to sites which have the FortiManager installed. We want
to ensure the FortiManager monitors t...
Hi, We have a number of FortiGate firewalls which range from SMB 60C
(being migrated to 51E) to large 1000D. We have purchased FortiManager
and installed version 5.4.3 as it covers most of our firewalls firmware.
I have recently learnt FortiManager c...
Hi - first post :) Is there anything special required when you want to
reach a host over a site to site VPN but the source traffic comes from
another VPN tunnel as traffic would be entering and leaving the same
physical interface? Is there also a spe...
scao_FTNT wrote:if you want to use FGT to send log to FMG (for FMG side
logging function), then you still need to let FMG IP be accessible by
FGT Would you also need to open the logging ports if the FGM is in a
DMZ? Or is the communication achieved b...
ergotherego wrote:You can set the source IP to use to connect to
FortiManager, on each FortiGate: config system central-management set
fmg-source ip [ IP ] end You would want to update the device in
FortiManager to use that same IP as well. Which int...
chall wrote:Sam.S wrote:My understanding, is if I import the first
FortiGate into the FortiManager under the same ADOM it will import the
policies and objects within the ADOM database. If I then import the
second firewall under the same ADOM, and the...
Thanks all. P2 under the VPNs are set to 0.0.0.0/0 however ,the select
radio button under the 'Quick Mode Selector" is not selected, non of the
radio buttons are selected. Understand the concept of different IPSEC
tunnels, thanks. We are running Vers...
