Hi, i have a fortigate 60D with two WAN Connections via PPPOE. I have
also 3 internal VLANs (100,110,120) and one VLAN (2100)is DMZ.All
Traffic is going over WAN1 because i set the priority on WAN2 to 10. I
want also that the traffic from VLAN 120 go...
Hi, i have a Fortigate 60D , the Config is: 2 WAN with 2 Static IPS
(PPPOE)4x Internal Lan ( VLAN 100/110/120/130)1x DMZ (VLAN 2100) I want
to use the VLAN 100/110/130) goes through WAN1, VLAN 120 goes through
WAN2.Following configWAN1 Interface Dist...
Hi, i tried this at the beginning ( set static Route WAN2 to a higher
distance), but this not worked. I read that if you connected via PPPOE
static route distance will not work !? Can you confirm this ? So i
decided to set Distance to 5 on the WAN1 I...
Hi, thx for answer. I think the Policy is correct. the Problem is that
in the mentioned policy the Gateway Address is set to 0.0.0.0 . If i
have a look in the Routing Monitor i have only one route with 0.0.0.0
that Points to WAN1 and so the traffic i...
You are leaving our website
You are leaving our site and we cannot be held responsible for the content of external websites
