We recently updated our wireless access points to a controller based
model. At the remote sites the AP's need to authenticate (ipsec) to the
control plane. Initial configuration and reboots of the AP authenticate
and work as expected. If my two Forti...
I have a policy set to allow the marketing AD group to access social
networking sites, the next entry is set to block. Everything works as
expected, until the user un-docks the laptop and moves to the wireless
network. Under the wireless network it i...
Any thoughts on making this design work.[ul]Each of our remote sites
have a 90D. They have a internet connection over cable, And a layer 2
(ENS) connection back to our main site (200D).I have all local networks
routing over the ENS interface (Learned...
They already have 2 DNS entries for the same host. One for the wireless
and one for the LAN. I understand how it works it just causes an issue
and was looking for a work around. Has anyone else have the same issue.
Another issue I came across is if a...
Thanks, The documentation in the video references ECMP, It is now only
called wan-load-balance. I will test it later, would I select Source IP
based, and setup the interfaces with the health check? I think I tested
this when I first setup the 90D, Wh...
