Hoping someone might be able to assist in fixing a configuration.
Currently have 3 separate networks that use the FortiGate for internet.
Lan 1 (192.168.100.0/24) and Lan2 (192.168.200.0/24) each are on a
separate interface on the FGT. Lan 3 (172.16....
I'm trying to setup a 200F so that multiple AD groups can connect to the
site using FortiClient (IPsec not SSL) for VPN access. Group1 should be
allowed to a subset of ips, group2 a different set of ips, etc. Should I
just create the groups on the FG...
So I'm working on Migrating from a different firewall platform that has
essentially 2 isolated departments that share redundant internet. I had
a couple of questions that hopefully a more experienced user with VDOMs
can assist with 1.) Is it best pra...
I'm trying to enable FIPS mode on a FGT 200F. I've entered the
following: config system fips-ccsetnextend and reboot the firewall, but
wasn't sure what the correct command was to verify if FIPS was enabled.
Do I instead have to do config system fips-...
If we currently have a 100D and want to migrate to 400F, what's the best
way to do so without using FortiConverter? I'd like to maintain all of
our custom profiles, policy routes and overrides without having to do it
all from scratch if possible. I i...
Thanks for this. I was able to move most of the configuration I needed
to under the 2 VDOMs and created npu vlan interfaces for routing in the
root VDOM. I set a default route in each of the VDOMs (I imagine I also
need to create the reverse root in ...
Thanks for the reply. If I run "show system fips-cc" I get this: config
system fips-ccend and if I run "show full-configuration | grep fips" I
get the following:config system fips-ccset fips-enforce enable