I have Fortinet 30e with 1 WAN interface.I have 2 x site 2 site vpn
tunnels, say VPNA 10.87.125.0 and VPNB 172.16.14.0Internal LAN is say
10.3.4.0I want to have traffic coming into VPNA to route out to VPNB and
VPNB to route to VPNA What is the best ...
KenThanks for your help but I am very confused. The remote lan address
schema eg 10.87.125.0 I cannot redefine, so I cannot assign it
192.0.1.1/31.In previous testing, when I had the PH2 Local and remote
address set at 0.0.0.0/0 the tunnel would not ...
Several things here: For PH2 tunnels, the tunnels will not connect if I
have them set to 0.0.0.0/0 for remote and local address on FTG. So I
have 2 x separate tunnels, each with different PSK and local and remote
addresses hard coded so to speak. The...
Oh this is interesting, so in Phase2 instead of specifying the local and
remote addresses I can just use 0.0.0.0/0 which will make PH2 generic
when having dialup user set in PH1? I have address names setup for the
local and remote networks for each V...
I looked at this last night but was worried because all the spokes in
the doc are on the same subnet (10.1.0.0/16) which is not the case in my
example. Also I have no control over the spoke routers other than to
advise the downstream staff to add rou...
You are leaving our website
You are leaving our site and we cannot be held responsible for the content of external websites
