Description This article describes the Apache log4j Vulnerability's
effect on FortiAnalyzer-Bigdata and how to Mitigate it. Scope
FortiAnalyzer-BigData 6.4, 7.0. Solution FortiAnalyzer-BD has components
that utilize log4j but the impact surface is ve...
Description. This article explains how to apply a Group Filter to LDAP
Remote Authentication to limit admin login access to FortiAnalyzer or
FortiManager to members of specific AD groups. Expectations,
Requirements Objective: Only users who are membe...
PurposeDue to a known issue, logversion field is not inserted in the
logs There are some reports which depend on these field causing them
come out blank.Expectations, RequirementsFor version
6.2.5.ConfigurationWorkaorund.- Remove the logversion filte...
DescriptionThis article describes how to disassociate Fortigate High
Availability clusters without the loss of logs when added under a
different FortiGate HA cluster because of the same HA group-name in
their configurations. ScopeFortiAnalyzer Soluti...
Description This article describes how a FortiAnalyzer can be added to
an ADOM on a FortiManager to have single pane of glass for Log Analysis
and Configuration Management for that ADOM. Although logs are still
stored on the FortiAnalyzer device, the...
HiPlease refer this link for configuring SD-WAN on
FMGRhttps://help.fortinet.com...ices%7CSD-WAN%7C_____0 For SD-WAN we
require following things 1.SD-WAN health check Server2. SD-WAN
template3.SD-WAN Interfaces.4. firewall Policies In FMGR, you can
c...
Hi AtiT If the keepalive failure messages are getting generated, can you
please check if there is any packet loss between peer network. Can you
also try disabling the INITIAL Sync on the Master device and then form
HA. RegardsMantaran SinghFortinet T...
Hi Abelio FAZ session counts are based on log message received after the
session is closed.While 'get sys performance status' output usually
shows current active sessions. In order to have apple-to-apple
comparison, the average session life should be...
Hi Marlon You can increase the disk quota for FortiGuard services. The
by default value is 50 GB and after reaching 80% of it, FMGR starts
giving the alerts, so please increase it. CLI commands-config fmupdate
disk-quota set value 128000 ----->128G e...
HiIn FortiAnalyzer 5.6, we can only have one wildcard Admin. So if you
are trying to create multiple wildcard Admins, it won't be possible.For
your requirement, RADIUS can be used. you can create one RADIUS wildcard
admin in FortiAnalyzer and on the ...