Technical Note: Optimize FortiGate-VM performance ...

Dinesh_FTNT · 09-10-2019

DescriptionThis article describes the steps to view the Default Trusted CA certificates.Solution1) To view on GUI :-Go to Security Profiles -> SSL/SSH inspection Select 'Deep inspection' from the right hand side corner drop downClick on 'View Trusted...

Dinesh_FTNT · 02-28-2019

DescriptionSD-WAN now supports IPv6. It supports all load balance modes, health checking (ping6), service rules for source address, source user / group and destination address.FortiOS 6.0 also increases the configuration limit for health checks and p...

Dinesh_FTNT · 01-31-2019

DescriptionOptimizing FortiGate-VM performance by configuring interrupt-affinity attributes to improve efficiency and resource utilization. ScopeFortiOS v5.6, v6.0SolutionInterrupt affinity (also called CPU affinity) maps FortiGate-VM interrupts to t...

Dinesh_FTNT · 04-07-2016

DescriptionThis article explains how to store emails on a remote NAS server in Fortimail.SolutionTo configure mail data storage, follow the steps below.1. Navigate to Mail Settings > Settings > Storage.2. Select the NAS server radio button.3. Select ...

Dinesh_FTNT · 02-03-2016

DescriptionThis article explains how to import a third-party certificate on a FortiAnalyzer.Solution1) Split the private key, and certificate in two separate files.2) Import the certificate via the CLI with the following commands.config system certif...

Dinesh_FTNT · 06-26-2015

Yes, If quota is not properly configured, you may face these types of alert messages. Now the disk usage should be fine and you will not get any issues.

Dinesh_FTNT · 06-26-2015

Hi, There is no difference in web filter profile. It does the same functionality in both NAT mode and Transparent mode.

Dinesh_FTNT · 06-26-2015

HI, If you have not allocated the disk space properly or if the disk usage is full, you will get the alert message.If disk quota is not configured properly, then configure the same . (System >> config >> Advanced >> On disk management, allocate the q...

Dinesh_FTNT · 06-20-2015

Hi dear,If you created vdom on the FGT, then some storage space will be allocated for each vdom. This could possibly the reason, you noticed full disk utilization.You can verify using the below commands.diag sys logdisk usage

Dinesh_FTNT · 04-22-2015

Hello, For the following FortiGate and FortiWiFi models, disk logging is disabled by default on v5.0 and Fortinet recommends logging to FortiCloud instead of logging to disk: FortiGate---- FG-20C, FG-20C-ADSL-A, FG-40C, FG-60C, FG-60C-POE, FG-60D, FG...

User Statistics

User Activity

Technical Tip: How to View the Default Trusted CA Certificates on FortiGate

Technical Note: SD-WAN configuration for IPv6

Technical Note: Optimize FortiGate-VM performance by configuring CPU interrupt affinity

Technical Note: Storing Email on a Remote Server in FortiMail

Technical Note: How to import a third-party certificate on FortiAnalyzer via CLI

Re: disk log error

Re: Fortigate Transparen Mode + Web Filtering

Re: disk log error

Re: How to clear out logs on disk

Re: Can't find old log

Technical Note: Optimize FortiGate-VM performance ...

Technical Tip: How to View the Default Trusted CA ...

Re: Server load balancing - redirect HTTP to HTTPS

Fortinet Training Institute

KCS