A month ago I went into production with two 1500D’s (HA A/P), two
1048D’s with MC-LAG as distributions, forty-one 448D-POE’s, and one
424D. All gear was running 6.2.0. Using Fortilink with loops. I
encountered the memory leak issue related to the wad...
Is there a way to associate an alias with a fortiswitch serial number?
The managed switch controller GUI is great but it is slow (6.2).
Modifying port vlans, etc. is just too time consuming in the GUI. From
the cli, when I edit a switch via the switc...
Any guidance on how to detect Huawei devices on a network running
Fortigate and FortiSwitch? I think that device detection will only give
me "Android" but not specifically Huawei. I was able to find Huawei MAC
address associations at
https://www.admi...
If you have trusted hosts enabled at all, then you will need to add the
IP of your polling/trap server as a trusted host.I just went through
this yesterday.
Nick, keep an eye on memory utilization. If you notice it creep up
again, just try restarting the wad process and see if that lowers memory
utilization (diagnose test application wad 99) will restart the was
processes. Yes, this was supposed to be re...
I am running FP421E-v6.2-build0246 Fortigates and Fortiswitches are
running 6.2.1 as well. Adding the AP management network to the trusted
host of the admin account worked for me. The AP is now connected an
operational.
Same issue here. I am not running FOrtiAP's but do have one 421E that I
wanted to test with. As soon as I authorize it, it goes to
"disconnected", even though I can SSH to the AP itself and from the AP I
can ping the gateway.
That is correct. I have my top switch going to one of my 1048's and the
bottom switch going to the other 1048. I am using DAC's to link the
switches within each IDF. When I was originally configuring the MC-LAG
between the 1048's, one of the steps wa...
