Hi to all,I would to expose to INTERNET an sstp server (only the TCP
port 443) and I would to attach it an IPS sensor. Which signature could
I use that match this traffic? Thanks in advance.
Hi to all,I would to allow the same bandwith to each user. Consider I
have a Fortigate with 2 interfaces, wan1 and ether1. All user are
connected in a private network under ether1 and go to internet using
wan1 interface at 100 Mbps (in up and down). ...
Hi to all,consider please my scenario. I have 2 interfaces: ether1
connected to a private lan (10.0.0.0/24) and wan1 interface connected to
the internet with a public ip address. The wan link is at 100 Mbps in up
and down but I would to assign to eac...
Hi to all,I use diagnose sniffer packet tool but I have problem when I
try to capture traffic into VIP.Example: I have public interface wan1
and internal interface internal1 on my fortigate. I configured a VIP on
wan1: all traffic with destination TC...
Hi to all,I exported configuration from a Fortigate 60c ( firmware
5.2.0) and I tried to import it on another Fortigate 60c (firmware
5.2.1) but some configuration like VIP and policy are not transferred on
second router. I also tried to downgrade se...
ede_pfau wrote:No, I haven't found any other way to share the
momentarily available bw. This means for example that on a 100 Mbps
line, with 10 Mbps upstream bw, I have to cap the single IP bw to 5
Mbps. Not nice but that's all there is.After all, tr...
