It's Friday. I cannot figure out how to move an endpoint in
FortiClientEMS 6.4.1. We have domain-connected it and I simply wanted to
move an endpoint or two into a new group to do some testing... I can't
seem to get "Move to..." to appear. Any clues ...
Hi,I just updated our Fortigate 100D from 5.4.5 to 5.4.6 and for some
reason the hairpin I had set up stopped working. It was set to route
from two (different) WiFi tunnels to an internal (lan) VIP with external
wan2 interface. I tried reconfiguring ...
Never mind....it is Friday. You have to create a group under the domain,
then move domain devices. I was expecting the new group to appear under
All Groups, not under the Domain.
Thought I'd post the "resolution". After opening up a support ticket,
and a rather lengthy debugging session with support, we were able to get
this working again by a process of trial and error. We eventually
disabled App Control on the inbound (wan)...
You are leaving our website
You are leaving our site and we cannot be held responsible for the content of external websites
