Description This article describes the steps to allow a specific YouTube
content video and block all other content from YouTube. Scope All
FortiGate units. Solution Enable 'Inspect All Ports' under SSL/SSH
inspection – Deep inspection. Navigate to Po...
Description This article describes the steps to configure FortiGate's
OID as a custom sensor on PRTG Network Monitor. Scope Any supported
version of FortiGate. Solution GUI configuration Log in to the FortiGate
device.To enable SNMP on the Interface:...
Description This article explains how to reset the packet count option
for a firewall policy. Solution GUIa) In FortiOS v5.01) Right click on
the value of Count field on the firewall policy under Policy > Policy >
Policy.2) Select "Clear Counters" fr...
Hi Ronny, You don't have to create the partition This is done by FSM
itselfPlease provide only the disk name that is for the clickhouse data
/dev/sde instead of /dev/sde1 During the initial setup provide this Disk
name and then Test and Save /opt/phe...
Hi Ronny, So for the initial setup - You need to provide 5th disk for
the clickhouse data - This is because on first install it will be
considered as standalone device making Super to be part of keeper and
data node as well. I suggest you can provide...
Hi @adem_netsys configFSM.sh should update the Super IP in it's DBYou
informed there are no clickhouse errors as well I think the issue is on
collector side - Can you check the value from this file and make sure
it's pointing to the correct IP ?cat
/...