Technical Tip: Suggested Parameters to use for a F...

adebeer_FTNT · 11-07-2025

Description This article explains how to send a reply in a TCL script from FortiManager to a query from the FortiGate. Scope FortiManager v7.4 and FortiGate v7.4. Solution When a TCL script is run from the FortiManager on a FortiGate, some commands s...

adebeer_FTNT · 08-27-2024

Description This article describes how to perform a sniffer trace for specific FTEIDs in GTP traffic. Scope FortiCarrier GTP. Solution It is sometimes necessary to perform a sniffer trace for packets from a specific TEID if it is not known what IMSI ...

adebeer_FTNT · 11-18-2022

Description This article lists useful parameters for the configuration of a FGSP cluster. Scope FortiGate v6.4, v7.0. Solution Suggested configuration parameters for a standalone cluster. config system standalone-cluster set standalone-group-id 11 se...

adebeer_FTNT · 11-17-2022

Description This article provides additional information about FortiGate Life Support Protocol. Scope FortiGate 6.4 and 7.0 Solution What is FGSP? FortiGate Session Life Support Protocol distributes sessions between 2 entities. In the defined configu...

adebeer_FTNT · 03-11-2014

Description Under certain circumstances, it can happen that an admin user was in config mode, and the session was not terminated correctly. Later, when an admin user wants to enter the config terminal mode, the following message is displayed:FBL-1#co...

User Statistics

User Activity

Technical Tip: How to send a reply in a TCL script from the FortiManager to a query from the FortiGate

Technical Tip: Perform a sniffer trace for specific FTEIDs in GTP traffic