My ISP issued me a WAN IP...call it 10.10.10.10 which I applied to a
network interface on my 200b. I set a route to 10.10.10.9 They are also
routing me another subnet call it 192.186.1.X. The internet is working
fine and I can NAT off of 10.10.10.10....
I have implemented some basic traffic shaping. I have a high priority
shared shaper with 1000kbps min 4000kps max on 3 policies and about 10
polices with a shaper of low priority with no minimums or maximums. And
a couple of policies with a medium pr...
I have a new fortigate 200b v4.0,build0313,110301 (MR2 Patch 4). I am
running my internal network on port 1 and my internet on port 3. These
are 100mb ports. I have configured the switch ports to 100mb full
duplex, and via command line on the fortiga...
we have a new 200b and 9 of the ports are in switch mode. I would like
the whole thing to be in interface mode. When I try to change the mode I
get a error about somethings in use. I have tried resetting to factory
defaults and I still get the same e...
I am looking at upgrading our fortigate and I am confused on the 200B
and 300A model. The 300A model is something like twice the cost of the
200B yet the 200B stats show it to have a lot higher firewall throughput
and more interfaces. Anyone know wha...
I am running the latest MR3 code on my 200b. I have seen some quirky
issues. I was not aware that it was not recommended to be on MR3. What
is considered the most stable release? How do you determine when to
upgrade? ---edit I found another post with...
Thanks for your response. It looks like the switch ports were still
trying to negotiate even after hard setting the speed/duplex. Once I
disabled auto negotiation it seemed to speed up the connectivity. These
are dell switches and I am not as familar...
