Hi, I have two FG 100D configured inside an active/pasive cluster (HA).
I have two ISP configured and I´m making load balancing throught static
routing, therefore I have two default static routes with the same metric
and priority. I have also configu...
Hello,I have a FG 100D (5.2) with two ISPs (connected to WAN 1 and WAN
2) and I need to configure:- Load balancing - traffic has to be
distributed between two ISPs - Fail over protection - If one of the ISP
has any problem all traffic has to be route...
With this configuration, right now I have: WAN1-> 798 sessions ->
183.51kb/s WAN2-> 548 sessions -> 614.4kb/s WAN3-> 2 sessions -> 36b/s
WAN4-> 115 sessions -> 167b/s I look forward your response alhashem;
thank you.
alhashem wrote:run the below command:get router info routing table
database do you see the static route of ISP 3 & 4 as a inactive
route?what kind of internet connections do you have?? what is the
framware version Hi, thank you four your help, you ca...
Hi, Thank you for your help. Yes, all static routes have the same
administrative distance and same priority, I've checked the phisical
interfaces and also have the same administrative distance. I have the
four ISPs connected and failover is working f...
Jzhang wrote:Hello, do you plan to use virtual-wan-link(CLI)/Wan Link
Load Balancing(GUI) feature? If yes, put wan1 and wan2 into
virtual-wan-link, like1.config system virtual-wan-link set status enable
config member edit 1 set interface wan1 set det...
