You should check SD-WAN feature, or you can give both WANs routes the
same distance, but different priorities. The latter gives you fail-over,
while SD-Wan gives you load-balancing. In my case, I used same distance,
different priorities scenario, and...
Oddly, I did the same operation as earlier (disable management, shutdown
forticlient, replace host file with fresh copy) but this time the
problem did not happen. I've been working all day with the forticlient
running and FCDBlog now only uses Under ...
I was having the same issue here on only one computer, after deploying
6.0.4 on about 15 computers. hosts file is 2.00 GB and FCDBlog.exe
memory usage goes up to 5.00GB, then suddently goes down to a couple of
MB and rises back up slowly. Windows 10 ...
So far so good, I did a snapshot and a full backup beforehand, then
installed SQL server express 2014 SP2 (was SP1), and it didn't crash in
about a week. I thought it was worth a shot. I haven't open a ticket
myself.
Like Alby23 mentionned, you are able to detect devices as long as you
have layer2 connectivity to them. It uses mac vendor ID to determine
device type. You can't detect devices on the WAN interface, because of
the routers between you and them. Your F...
