Most Liked Posts Recent Solutions
No Content Available

User Activity

Scenario - FG200E on datcenter side, FG60E on branch side Using a policy based route I'd like a particular source IP on the branch side to route all traffic via the tunnel to the datacenter then out on the internet via the outbound interface IP. Runn...
Fortinet to Fortinet, 100E to 60E, IPSec Tunnel, gigabit connection on the 100E and 400mbit on the 60E.SMB transfers are slow, about 2 or 3mbps. Have adjusted tcp-mss in the IPV4 policy for the indicated branch and on the IPSEC interface itself to 13...
Deploying my 6th fortinet 60e - going not bad. The tunnel on this one flaps every 2 minutes or so. It's a route based VPN with a tunnel interface. Link monitor: Interface TUNNEL1 was turned downthen a second or so laterLink monitor: Interface TUNNEL1...
I have 3 FG60E's with route based IPSEC tunnels back to our datacenter.Once a month or so, they'll suddenly start routing traffic over WAN1 for the private subnet instead of the VPN tunnel interface (viewable in the taffic logs). All three of them do...
I'd like to know if there's an easy set of CLI commands that disables web filtering, SSL screening, antivirus, any ALG etc. etc. I've had a couple weird issues where traffic to one IP over VPN stops working (it's to our PBX, and it's SIP traffic, but...
My Top Kudoed Posts
My Accepted Solutions
Kudos from