Hi all guys,I have a problem with port forwarding on my new FG61E with
FortiOS 5.4.1. Schema:Internet <-> (Public IP) Router (192.168.123.1)
<-> (192.168.123.10) FG61E (192.168.69.254) <-> Server1 (192.168.69.156)
In the provider router the needed po...
Hello guys,I have a really strange problem with a FG 60D 5.2.4 and a
Cisco WAP131 WiFi Access Point. The WiFi Access Point is connected on
the internal network interface, where cabled clients are also connected.
The WiFi clients gets an internal IP A...
Hi guys, as the title says, I cannot authenticate devices using
WPA2-Enterprise on my fortigate (running in conjunction with FortiAP). I
tried my LDAP settings and they are working fine. I can use the LDAP
server in order to authenticate my users usi...
Hi guys, I don' t visit these forums since some time now. There' s the
situation: FG External IP : 12.13.14.15/32 FG Internal IP :
10.0.0.254/24 I' ve correctly set up a Load Balancer as follows: 1.
Health Check : PING 2. Virtual Server - VS-Name - T...
Didn't find any solution for that problem, so i decided to factory reset
the firewall and to start from scratch again.I've reconfigured
everything again, and miracle, everything is now working correctly.
Thank you alll for the time you dedicated over...
Hi Mike,thank you for your reply. Unfortunately this router must stay in
routing mode with NAT enabled. I can set in in PPPoE Passthrough but I'm
going to loose a feature that I don't want to lose, the 4G USB Internet
Backup.
Hi Ede,thx for reply.To answer your questions:1. I've not set it in the
VIP, it's defined as 0.0.0.0. I also tried to set up an IP address to
translate (Wan1 IP) but it doesn't change.2.Default route to gateway is
set as you can see there:FG61E # get...
