You are leaving our website

Mono_FTNT · 12-21-2023

Description This article describes that if a cluster fails over, the link-monitor status will only update after a cold start timer of 10 seconds.It will take the configured failtime plus 10 seconds to detect the link-monitor status. Scope FortiGate v...

Mono_FTNT · 01-25-2023

Description This article describes a supplementary explanation to prevent an unnecessary problem for configuring SSL VPN that requires users to authenticate using a certificate with LDAP UserPrincipalName checking. Scope FortiOS v6.4, v7.0, v7.2, v7....

Mono_FTNT · 08-13-2022

Description This article describes that if a site-to-site IPsec VPN using dialup (dynamic) mode like below is configured: config vpn ipsec phase1-interface edit "to_BO" set interface "port3" set type dynamic set peertype any set dpd disable set propo...

Mono_FTNT · 01-17-2019

DescriptionIf a FortiMail in Gateway-Mode stops forwarding emails and the following error message is observed on the console: - 01.15-01:03:02 Critial error, cmf_lock.c, __cmdb_rwlock_lock, 252, semid=32769, pid=14489, errno=22 timeout=0 exiting... T...

Mono_FTNT · 11-28-2016

Description This article how to release quarantined mail by clicking the 'Release' button on the Webmail GUI when the FortiMail is configured to quarantine a mail (personal quarantine) through a content profile. Solution To enable the release functio...

User Statistics

User Activity

Technical Tip: Additional time is taken to detect a link-monitor status after HA-failover.

Technical Tip: Supplementary explanation for 'SSL VPN with LDAP-integrated certificate authentication' on FortiOS Administration Guide

Technical Tip: Static route defined over IPsec VPN tunnel is always on a routing table of IPsec receiver

Troubleshooting Tip: FortiMail in gateway-mode stops to forward emails.

Technical Note: Quarantine mail 'Release' button on Webmail GUI does not release mail

KCS

Fortinet Training Institute