Hi, a few days ago i updated from 6.0.4 to 6.2 and now i got every 10
sec's this messages in the system log: our AdvOtherConfigFlag on wan1
doesn't agree with fe80::1 our AdvManagedFlag on wan1 doesn't agree with
fe80::1 our AdvOtherConfigFlag on wan...
Hi, since i modified some VPN parameters i got no content in the IPsec
Tunnel list in the GUI. I got only the turning dots, no error message,
nothing, even after some minutes, nothing. Nearly the same in the
Monitor page, after a reboot one time the ...
Hi, in my environment i have 2 WAN interfaces with IPv6 and one LAN
interface which is using that. The IPv6 addresses on the LAN are
configured manually, and i use 2 policy routes to send LAN prefix A to
WAN1 and LAN prefix B to WAN2. All is working ...
Hi, i'm currently trying to get IPv6 configured. I have 2 WAN interfaces
each has its own prefix. WAN1 i got working. Here i'm able to deploy
addresses via SLAAC or use static IP's. My LAN interface got a internal
statc fd24 address, all my servers h...
Hello, i want to replace a LANCOM 1781EF+ with a FG100D and have now a
routing problem, i don't find how co configure the FG that i have the
same features. I have 2 cable business WAN lines, where i got a fixed
public IPv4 via DHCP. I want to use the...
Yesterday i had a issue with 6.4.1 too, after 24 days in my homeoffice
my internet access was gone, so i logged in to the 100E and the device
shows "conserve mode". I made a litte research and all the memory was
used by "480" tasks with the name "nod...
