I have a scenario where I have five locations in differing counties that
need access to two servers in my network. As of now I have five separate
IPSEC tunnels setup for this. Hardware: main site (hub) FG-110C each
remote site (spokes) has a single F...
Site1 (FG-110C)-ALL TUNNELS TERMINATE HERE TO SERVER1(192.168.3.x) | | |
| | | | Site3 (FG-50B)-IPSEC TUNNEL FOR SERVER3(192.168.1.x) | Site2
(FG-50B)-IPSEC TUNNEL FOR SERVER2(192.168.1.x) Two locations with FG-50B
will be connecting to a FG-110C via...
Hello I noticed on the 50B you cannot go from switched mode to interface
mode via the GUI in the Network settings. I really need this feature but
I cannot run down the CLI to get this done. Can this feature even be
done on the 50B? Thanks
Currently I have a IPSEC VPN connection setup between site1 and site2.
Everything works fine 98% of the time however it does eat up some
bandwidth on our main line and we do have a dedicated Point to Point
line we pay for (P2P). The current setup can...
I have several users using a SSL VPN configurtion that gets them to the
internal servers. One of the users needs to have a static IP because
they will be accessing a new server service that needs static IPs of the
workstations to push messages to. Is...
Similar problem. FG100D to a FA100C (MR3 Patch8). The FA100C (latest
build) shows up just fine as a registered unit and permissions are OK.
It seems some log data is being sent to the FA but when I hit test
connection on the FG100D under connection s...
Yes I entered in the remote WAN1 IP address. I' ve been getting Phase 2
error 37125 however the reasons for this according to the docs is quite
broad. All my IPSEC tunnels I' ve left the phase 2 options default. The
only time I had to change the remo...
Selective I' ve just gotten some time to work on this issue again and I
hope to get it sorted out today. I' ve done all the steps given to setup
interface mode with no luck. I did the following: 1. Create vpn phase 1
and 2. I used default settings an...
I added a new PHASE1 and PHASE2 in interface mode. Then I went up and
created a ZONE with the new IPSEC tunnel in it. After that I went in to
make a firewall policy for VPN_ZONE >>>>>to MERG. I added the remote
site servers to VPN_ZONE and my local s...
I' ve never setup zones before so I' ll have to read into it. I went to
create a new zone and it asked which port I wanted to add the zone to
however neither of the two ports that it wanted me to apply to the zone
have anything attached to them. Mayb...