We have some computers that are configured with public IP address, the
current setup looks like top left corner of the attachment.Because these
servers are directly on the Public Internet, we would like to apply some
policy to the incoming traffic, s...
this method stills work with Windows 10 build 18363 Cohmert wrote:Hello,
i have the same issue.I could solve it but i am not satisfied.The
problem with connecting only affects win10 clients. I have serveral
clients where the connection settings are s...
ede_pfau wrote:Sure. Just create a VLAN port for VLAN 233 on physical
port 26.But hey, to really isolate a server group you could just put
them on another port - the 1240 has got some!Then you can control
traffic from and to that group with policies....
ede_pfau wrote:Yes, basically.The gateway of the private server LAN
would be the port on the FGT, not a switch in between. Even if the
'switch' 192.168.2.1 is a PANWFW, it would run in transparent mode; even
then, the next hop is the FGT. The routing...
ede_pfau wrote:As the FGT is acting as a router you cannot have the same
subnet on different ports. Each port spans a broadcast domain of it's
own.Put your servers on inside ports (as depicted) but with IP addresses
of a private LAN (RFC 1918). Then,...
