I have always been curious why Fortinet did not make better use of the
HA status light on these appliances. Most HA devices (Cisco/Juniper/etc)
use this light to not only indicate that HA status, but which unit is
active. Generally standby unit is " ...
I select dedicated management for larger units, but in any case there is
a MUCH easier way if you can' t or don' t want to do that. From SSH
Session on master unit: exe ha manage Press ? after manage and it
will list the other unit.. i.e exe ha mana...
I have some experience with this so I' ll try to help. First off, the
40C is a very small unit. If you' re going to want to turn on all the
UTM features, you will likely not get 30Mbit throughput. If you can
shoot for newer rev of 80C or higher that ...
I always use the Proxy Antivirus figures as worst case.. which for this
model is 1.3Gbps. However that is assuming that you use all features for
all traffic flows which is terribly inefficient and likely unnecessary.
You need to have the understandin...
Have you tried submitting a new App request to FortiGuard.com? This may
help get the ball rolling. I added in several applications using this
method. http://www.fortiguard.com/applicationcontrol/appform.html
Anything you do locally is overwritten by FMGR. This is why it' s
important to review the " Preview" of installation carefully. It isn' t
overwritten with a whole new config, only the delta (or difference) of
the configs is sent. If you check Preview...