Hi all, I am faced with a situation in which we are using RIP in our
environment to advertise routes to a parter (not ideal I know but this
is just the way it is right now). I am trying to restrict the routes
that are advertised to the partner using ...
Hi All, I have a question. I am working on my test lab in preparation
for a system upgrade. In my test lab I have 2 x Fortigate 60B' s,
configured in a HA cluster. I am looking at applying patch MR1 Patch 8
to MR1 Patch 4. My procedure is as follows:...
Hi All, I have an urgent problem that I need assistance with. I have two
IPSec tunnels between my two sites. In both firewalls the tunnels are
showing as up on both sides. No traffic is however passing over the
links. When I debug the link I get the ...
Hi all, Does anyone know of a method to display a disclaimer for users
once they have successfully authenticated using the SSL VPN. We have
contractors with very limited access and I need to present something to
them after they have authenticated whi...
Hi Bill, Thanks for the information. I was hoping to see something that
allowed you to compare two values (in the CLI) that would allow you to
easily distinguish if the devices were in sync (same number) using ' get
sys ha status' this would be good ...
Hi, Thanks for the response. How do you know when the Master/Slave are
in complete sync though? Are you able to compare two values that show
the units are now idenitical (fully sync' d)? Thanks, Darren
Issue is now resolved. The P2 of the two IPSec tunnels had some how
merged into one? No idea how this could happen. Anyway, contacted
Fortigate, the fix was to reboot the firewalls at each end. They seem to
think it was a HA problem? I am applying an...
