I am using redundant Tunnels towards other Destinations (e.g. 4 Tunnels
from Hub -> Spoke ) I run OSPF over this Tunnels, so i get 4 routes with
same chracteristics. ECMP seems to work, i get Sessions on all
Tunnel-Interfaces. Now i tried to favor on...
I am trying to integrate Fortigate in a monitoring tool. As we have the
switche monitored using snmpv3 i tried that with Fortogate as well, but
no luck. I' ll test anything with Paessler SNMP-tester, which is a handy
little tool for check whether snm...
I' d like to generate a alertmail, to see whether it is working. I
created an smtp server configured an alert mail. In the past i could
test-connectivity in release 5 i can' t find a gui option and also could
not figure out a cli command. any hints?
We want to use a FAP14C and utilize the lanports on the fap14C for
connecting Clients into (different?) SSIDs. Is that possible? Is that
possible on 4.3.X? I found on 5.0.6 that i could configure (all) ports
to be bridged into a ssid. I could not fin...
I have a FAZ100C in my LAB which has run out of service. now i wanted to
test the new release 5, but noticed that the hdd probably went dead, as
i am spammed with a2.00: exception Emask 0x0 SAct 0x3 SErr 0x0 action
0x0 ata2.00: irq_stat 0x40000008 at...
AFAIK (on Fortinets site, no clue about Linux) the fortinet will build a
session, hence packets entering on WAN1 will leave the fortigate on WAN1
as long as there is a (default) route pointing to that interface and the
route is in the routing table.Y...
A/A still works by load balancing UTM (AV/IPS) stuff to the second
Fortigate. Load-Balance all trys to load balance even single TCP
sessions to the secondary Fortigate.The overhead needed for that (New
TCP SYN is coming to fgt master, replicate that ...
