Hi, We are running 2x 200D' s at our HQ site in HA mode. We have a
mixture of 60C, 80CM and 90D' s at our remote sites. Recently I' ve been
upgrading our 60C' s to 90D' s to allow more FortiAP' s devices. On the
90D' s, I updated the firmware to 5.0....
Hi, We have a Fortigate 110C with FortiOS 5.0.1. I have been trying to
setup a Guest Wireless Network with the Captive portal enabled. I
created a Wireless Guest group and a admin account restricted to
Provision Guest Accounts associated with this Gr...
I' m trying to add all of our site to site interface VPN' s to a Zone,
allowing us to create a couple of simple policies, rather than 2 each.
But the VPN' s do not appear as available interfaces under the Zone
configuration. These are New VPN' s with...
Thanks for the replies. I do have HTTP/HTTPS access enabled and it seems
to work fine locally, its just over the VPN. Thanks Ede, I' ll compare
both configs, just seems odd that its only the 90D' s I have a problem
with. Gareth
I have looked into this and found in the documentation for MR3 Patch3
the below: 159005 Zone member interfaces may not be listed correctly. So
I will update to Patch 4 tonight and post an update. Thanks
Thanks for your reply Paul. I have only setup Phase 1 and Phase 2 of the
Interface (WAN1) VPN' s, so they' re not referenced anywhere. It even
states that under Interfaces. But I have a Zone which only 2 show, seems
very strange. Thanks.
