Hi all, just to make sure that I didn't misunderstood.... ;) Beginning
with FortiOS 6.4.2 there is the possibility to modify the arrp-profile
in a more granular manner.In the (only possible) default profile dfs and
weather channels will not be includ...
Hi! Today I noticed some discrepancy between the actual operating
Channel an the displayed one (both in AP and FGT)Clients had a short
outage, although there was no DAARP or Radar action going on.Afterwards
the AP & FGT showed CH 116 as the operating...
Hi @all in the last weeks I noticed some strange behaviour of the PoE
Ports on a FGT 81E PoE.The lower Ports (1-4) did not function properly
anymore..at Devices did not work well, .af seemed to work better.An .at
device on Port 11 for example worked ...
Hi @all, has anybody succeeded in connecting a FAPC24JE as a Remote AP
with IPSEC Datachannel security?It kinda seems to work, I see the WLC
FGT responding to IKE requests..... but I wasnt able to establish a
IPSEC Datachannel.It could be the WAN Set...
Hi! Yes this is possible.in order to re-use the SSID you have to set the
following via CLI: config wireless-controller settingset duplicate-ssid
enable Then you are able create 4 Wifi Interfaces with different Subnets
but the same SSID.If you are tun...
Hi ipranger, really strange.... Some thoughts that came to my mind: are
the affected ssids tunnelled or local?If tunnelled, is the Datachannel
Security TLS or IPSEC?Are Protected Management Frames enabled on the
ssid?Does it also occur without WIDS o...
Hi Safwa, Check on which Band the clients are connected and try to add
the MIMO and Rate columns in the Wifi-Client Monitor on the FGT. Rule of
thumb: 5GHz usually provides better throughput, more spatial streams
(ex. 3x3 MIMO) also.If you get approx...
Try to extend the Widget to 4x1 since this overlapped view is kinda
crappy ;)In the past I sometimes found the overlapping traffic curves to
be inaccurate.
