After changing the VDOM containing the IPsec tunnel interface on the
FortiGate 60F (firmware version 7.4.3) to a non-management VDOM, the
IPsec tunnel went down upon reboot. Prior to the reboot, the tunnel
remained up.After switching the VDOM back to...
Regarding the VRRP-redundant network device (FortiGate 60F) connected to
the HA-configured FortiGate 200F (7.0.5), the setup involves the primary
200F connected to the master 60F, and the secondary 200F connected to
the backup 60F. Ideally, when the ...
After upgrading the firmware of the FortiGate 200F in an HA setup from
7.0.5 to 7.2.2, the VPN tunnel configuration was lost. Ideally, we would
like to upgrade all the way to version 7.4.3. Please advise on how to
prevent the VPN tunnel settings from...
After upgrading the firmware of a Fortigate 200F in an HA configuration
from 7.0.5 to 7.2.2, the HA synchronization was lost. Ideally, we would
like to upgrade all the way to version 7.4.3. Please advise on how to
resolve the issue if synchronization...
After updating the firmware of the Fortigate 60F from 7.2.2 to 7.2.4, I
encountered that SNMP responses stopped coming from the interface
configured on the non-managed VDOM.The configuration is as follows: SNMP
server → Managed VDOM → Non-managed VDO...
Thank you all for your responses. I'm reviewing each reply carefully, so
I apologize for the delay in getting back to you. First, in response to
Toshi-san: all the VDOMs mentioned in my question do not have internet
connectivity. The IPSec tunnel int...
Thank you for your reply.This is a preliminary response.I changed the
management VDOM from the one originally hosting the IPSec tunnel
interface to another VDOM, using the method described in the following
URL: Fortinet Administration Guide – Managem...
Thank you for your response. I had mistakenly assumed that communication
would continue seamlessly as long as the secondary unit was active.Since
adding more devices is not feasible, I believe using a monitor interface
would be the most desirable sol...