Hi All, Currently we are facing issue when access or open a file located
at File server (10.2.3.3) through IPsec tunnel located at branch
(Watchguard). We are able to open the shared folder using map|smb
folder. However when open, copy or access the ...
Hi All, Currently the customer environment is using FortiGate as L3
device with multiple VLAN interface, Veem backup server (10.101.12.171)
is connected to the VLAN interface production which group to Zone to
minimize multi policy deployment. We enco...
Hi All,I have post on creating sub-interface and create a firewall
policy for inter-vlans communication which connect direct with access
switch using trunk port. All communication between client and interface
was successfully establish and functionin...
Hi All, Appreciate for the help and advice .Based on diagram below
firewall is connected with 3 access switch using trunk port with all
client and switch pointing to VLAN 3 interface (IP 10.101.3.254). Layer
3 switch with IP routing enable will able ...
Hi All Currently one of my client provide us an information of network
diagram which include multiple and used Fortigate as gateway and routing
for vlan as show from screenshot. My question is does different VLAN
able to act as gateway without any in...
dennisv wrote:@azwanarifYou should not put port 23+24 into an HP
Trunk.HP Trunking is only for load balancing multiple connections from
one HP switch to one Fortigate.In Fortigate this is called an aggregated
interface.This is used for increase of ba...
@dennisv Current setup is HA enviroment whereby Hp port 23 = FortiGate
(Master) port 1 and Hp port 24 = FortiGate (Slave) port 1. @rwpattersonI
have tried only tagged vlan for trunk port 23 & 24 and untagg for the
remaining based on vlan assignment e...
Hi @dennisvHp switch is connected directly to Fortigate port 1 (Hardware
switch) and using Zone to combine all VLAN with "Block intra-zone
traffic" disable to reduce multi policy between Vlan. VLAN 1 is
connected to physical port 1 using IP 10.101.1....
sw2090 wrote:I have to correct myself: FGT only know tagged. They will
not touch the VID in a packet and they will only accept packets with the
right vid on a vlan interface Thanks everyone for the info sharing,
Below is the current working HP Procur...
