Hello, I would like to know if some of you have a recommendation for a
configuration between a Cisco switch port-channel and a Fortigate Agg
FortiOS5 On my Cisco configuration I' ve used this for the physical
interfaces channel-group 1 mode active sw...
Hello, I doubt there is an answer but I have a virtual server that load
balance connections on 2 real servers. On the interface Firewall Objects
> Monitor > Load Balance Monitor I can see that I have X sessions for
RealServer1 and Y sessions for Real...
Hello, Just to let you know, the port-channel is now static/mode on but
we still have output errors seen on the Cisco Po Po1 => 0,022%
(expressed in packets) Gi1/0/46 => 0,017 % Gi2/0/46 => 0,039 % I know
the percentage of error is quite low but ther...
emnoc, thank you for your answer. I had forgotten to mention that flow
control is disable by default (input direction) on Cisco not available
on the output direction.
http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/software/release/12-...
Hello, I don' t mind people talking about the LACP counters problem on
this thread because I asked the Cisco vs Fortigate configuration
recomendation as I see output drops on the Cisco side. The latter
statement is my real problem. emnoc: My configur...
Hello, Thank you both for your answers. Regarding my Cisco configuration
I just wrote the important lines (not the syslog or load-interval
related commands) and of course I do use trunk with the firewall. I
didn' t write the channel-protocol lacp com...
Thank you for your answer. I haven' t been able to find the
corresponding OID, what are the OIDs polled by you PRTG ? NB: I' m not
talking about nat sessions but about the load balancing
You are leaving our website
You are leaving our site and we cannot be held responsible for the content of external websites
