Hi!So i'm facing a strange issue with wildcard address object (FQDN).If
i configure the object as *.learn.microsoft.com i cannot reach anything
from my client, not even the "microsoft.com" domain.If i configure it as
*.microsoft.com i can reach the w...
Hi!So i have an HUB&Spoke topology (OS 7.4.6), the 2 HUBs have only 1
link each meanwhile Spoke has 2. Everything seems working fine, i
receive the BPG adv from spoke and viceversa until i try to shutdown one
of the WAN link on the spoke side.So i ha...
Hello to all,I’m trying to build a single spoke hub & spoke (Dual hub)
topology using the overlay template provided by FMG 7.6.3.The
architecture is formed by 2 VM fortigate hubs in 7.4.6 and an onprem A/S
pair that acts as spoke in 7.4.6.Full intern...
Hello!I'm facing a strange issue with my FMG on 7.6.3, basically i'm
trying to create an overlay template but i cannot select any of my
firewalls, is that a bug from 7.6.3?I tried also to reboot the FMG, but
nothing changed.
I found the issues, basically the healthchecks were configured toward
the same loopback used by the hub to close the ADVPN. i think that was a
misconfiguration made by the overlay template that i used on the FMG. so
i replaced the healthcheck IP with...
even if i enable the link down detection, BGP is still trying to use the
dead VPNs.Those other zones (WAN 1 and WAN 2) were created by the
overlay template (thanks to FMG), but i see that only zones HUB1 and
HUB2 are used in the BGP and SD-WAN health...
I figured out the issue, so basically the RR client was turned on the
branch side. so i removed that configuration and the routes was
advertised correctly.
