We have been using link-monitor to monitor ping to GW, but after setting
up link-monitor, HA switchover due to link monitor failure occurred
frequently during periods of high traffic spikes.When we checked the
ping statistics of link-monitor, we foun...
@funkylicious Thank you very much.As you mentioned, the L3SW is
redundant with HSRP, so the L2SW must be connected to both L3SWs as
shown in the figure.Once we make minor modifications to the link monitor
parameters and if the problem is not resolved...
@funkylicious L3SW#1,#2 are also connected to L2SW#3, so there is no
crossing between L2SW#1 and L2SW#2 in this special configuration. (to
avoid loops).All links are on the same segment.If a failure occurs on
L3SW, the FW cannot detect the failure of...
@Toshi_Esumi This is because the service is contractually provided as 10
Mbps. It is possible to change the contract and increase the speed, but
after setting the link monitor, HA switching occurs frequently, causing
users' communication to be delaye...
