Hello all.I've a problem with a subordinate firewall. LACPs status are:
primaryFGT600_1 # diagnose netlink aggregate name LACP01LACP flags:
(A|P)(S|F)(A|I)(I|O)(E|D)(E|D)(A|P) - LACP mode is Active or
Passive(S|F) - LACP speed is Slow or Fast(A|I) - ...
Hello all.Can somebody explain me what's the difference between the two
DHCP relay modes?I've spokes connected to hub via DIALUP IPSEC VPN.DHCP
server is behind the hub.In the spoke vlans I configured DHCP relay
feature.I don't understand if I need t...
Hello all.I'm migrating 6.0.8 to 6.2.8 EMS server. On the higher version
is available a new feature to read AD user/computer groups.I associated
an installation profile to an AD group named
"domain/Forticlient_upgrade" applies new telemetry gateway I...
Hello all.I'm facing a problem with VPN IPSEC.On the LAN interface I've
two addressing, primary and secondary, and I would put into the
encryption domain of the phase 2, the secondary subnet.It seems all
fine; phase 2 goes UP, but the traffic doesn't...
You're right!I applied a correction: "What could it be? The traffic from
EMS server to AD server doesn't pass through a firewall, but only
through a L3 switch. It shouldn't be blocked." However I also opened a
ticket to Fortinet TAC and maybe I found...
Hi Ismael.If the endpoints already have FCT installed, you can put
telemetry gateway (EMS) on their configuration. On EMS you've to
discovery the domain and the endpoints will appear in the assigned OU.
If you work in a workgroup, the endpoints will ...
Very strange!After I wrote it worked.I restarded the FGT and done againg
the VPN configuration; I see the route for the secondary subnet, the
phase 2 come up and the traffic passes.Sorry and thx.
You are leaving our website
You are leaving our site and we cannot be held responsible for the content of external websites
