Hi!I'm struggling with CLI template in FortiManager right now. I must
delete all dhcp servers and I made script where I use purge command, but
the problem is, it gets stuck there. There is prompt where user must
press y to confirm what you are doing,...
Hi! Go to VPN -> SSL-VPN portals. There you can define tunnel mode.
Select "Enabled Based on Policy Destination". Or in the cli as showed
below.config vpn ssl web portal edit tunnel-access set split-tunneling
enable end Check this manual: Link
Hi! What firmware version do you have?You should create HC to specific
IP address and configure SLA for that. You could test with spillover,
but in my case I use source IP instead of Spillover. You could test both
and check, what works for you the be...
Thanks, but it won't work. I found out that. Fmg 7.4 have bug that if I
import device then i can't save Fmg configuration until Devices are up
and config status shows synced. Then I can click save and manually
install policy package to push changes i...
Please share ipsec configuration where is also showed phase1 and phase
2. Please also add two FortGates configs. Don't forget to hide
classified information.
