Re: Creating new IPsec S2S Tunnels with FortiManag...

Pradhumna_FTNT · 08-26-2009

DescriptionThis article explains how to create a user report in 4.0 in order to report on a specific user's web browsing habits. (This is similar to the forensic style report in 3.0).This article is applicable only until v4.0 MR3 patch 8. It does not...

Pradhumna_FTNT · 12-17-2015

Hi, If the phase2 is configured with Source and destination network as 0.0.0.0/0, great ,else first step would be to create phase2's for the MPLS networks. Then create a firewall policy from VPN interface to MPLS interface (Where the MPLS router is c...

Pradhumna_FTNT · 12-17-2015

Hi , 1)Create a static default route.2)Create a firewall policy and enable NAT on the policy. Please check this linkhttp://help.fortinet.com/...ic_routing.022.34.html Regards,Pradhumna chandra

Pradhumna_FTNT · 12-17-2015

Hi Alan, You can use this command, diagnose fortilogd msgrate-device diagnose fortilogd msgrate-type You can also check if the severity in the log filter settings was changed.config log fortianalyzer filterset severity //ideal configurationend Regar...

Pradhumna_FTNT · 06-18-2015

Hi , For the reporting on the fortigate we need to make sure the disk logging is enabled. You can verify these commands config log disk settingset status enableset log-quota 1000 //allocation disk space in MBendAnd under Log Settings enable local rep...

Pradhumna_FTNT · 06-15-2015

Hi, Thanks for your update. If your device has NP (Network processor) after the connection is setup the traffic gets offloaded to Network processor, due to which we will not be able to see the complete traffic details in the log. We can disable this ...

User Statistics

User Activity

Technical Note: How to create a FortiAnalyzer user forensic analysis report

Re: Fortigate 90D two network

Re: Allow internet

Re: Giant spike in logs being sent to FM

Re: Fortigate can't generate report

Re: Session logging

Re: Creating new IPsec S2S Tunnels with FortiManag...

Re: Session logging

KCS