I have an IPSEC VPN tunnel established between two Fortigate Fortinet
50B' s. Each Fortigate is connected to the internet via WAN1 through a
DSL modem. Phase 1 and phase 2 of the IPSEC tunnel are properly set up
and the tunnel is shown as up on both ...
Hello, We have hired a security company to perform a penetration test.
One of the tests they performed reported a risk. Here is the test
parameters: Using: ncat --ssl (our static IP) 443 GET / HTTP/1.1
HOST:(our static IP) EXPECT:" > The
response (gi...
Hello, We have hired a security company to perform a penetration test.
One of the tests they performed reported a risk. Here is the test
parameters: Using: ncat --ssl (our static IP) 443 GET / HTTP/1.1
HOST:(our static IP) EXPECT:" > The
response (gi...
We have several power outages at our locations. We use the Fortinet 50B
firewalls exclusively. Quite often after the power returns, the firmware
on the firewall is corrupted. What technique could we apply which during
a power outage we could remotely...
I have several firewalls which need new policies. I have opted to learn
the CLI commands to make the job faster and easier. Unfortunately the
firewall policy names are numbers; therefor, without knowing which
numbers are already used by policies...wh...
Hello, They are pen testing a: Model: Fortigate-60 Running: Firmware:
Fortigate-60 2.50,build171,031215 And it appears that one of the items
in the response from the Fotigate 60 is: Server: FortiWeb-2.2.0 So I was
assuming that Fortiweb was running o...
Thanks for all the valuable inputs so far. I was reading the technical
note: FortiGate Logging with FortiOS 3.0 Technical Note Version 3.0 27
November 2006 01-30000-0381-20061127 Which states that I can go to
System > Network > Interface and turn on ...
