I’m working with a BGP setup involving three FortiGate
firewalls:FW-AFW-BFW-CFW-A has two BGP neighbors with FW-B: one over a
point-to-point link and another over an IPsec overlay tunnel. Both
neighbors advertise the same routes to FW-A. However, I n...
The traffic through p2p is only for oracle networks and some other
traffic configured via SDWAN. I need to have this p2p underlay (only
oracle traffic) and overlay (local traffic). Using local pref is not a
good choice because all traffic will use th...
It should be, but it isn´t lol. FW-B receive routes from FW-A after p2p
came back, but it didn´t advertise to FW-C. This is happening because on
the routing table of FW-B, the best route to FW-A is through SDWAN
overlay, that´s why it isn´t advertisi...
Here is attached. FW-A needs to go to oracle via P2P with FW-B. But
need´s to use only P2P link. When this P2P goes down, FW-C needs to stop
to receive routes from FW-A, but still receives because of SDWAN between
FW-B and A. That´s why I tried to se...
Actually my environment has the eBGP multipath enabled. I have to
communicate my local networks via SDWAN overlay (with alot of neighbors)
between these 2 firewalls (A and B). But FW-C is a network from Oracle.
The traffic needs to go only in the poi...
You are leaving our website
You are leaving our site and we cannot be held responsible for the content of external websites
