Dear Fortinet Community!FWF30E-3G4G (6.2.10) is using onboard LTE modem
with SDWAN. It works only with direct routes, and doesn't work with
static route sdwan--> 0.0.0.0. LTE gets dhcp address with /32 mask - so
there is no any gateway... If I downgr...
Hello! Guys, need help... Cant understand the problem. Have a lot of
branch offices with FortiWiFis 30E-3G4G-INTL there, and 300D in the
center. All of them are connected with ipsec vpn to center (300D). So...
Yesterday I was removing old Zywall with...
Hi guys! I have strange situation with users. After deploying FSSO some
users started to lose their memberships in AD. Only groups, that are
used for Fortigate are affected. I have FG300D and AD W2012R2. I use
collector for AD controllers (20 DCs) lo...
Good morning Vietnam! Can anybody explain to me how should I build
backup IPSEC interface? Found articles about how to configure fortigate
with to ISPs, but no one about second fortigate with only one ISP.
Should I configure ipsec as a dialup user? B...
Hello! Guys, need help to solve the problem. There is one ISP, one cable
is connected to the first port of FG300D. I have a block of IP addresses
– for NAT and Transparent modes. I need to create 2 VDOMs - one of them
will work in NAT mode, the other...
For exemple, ZyWALLs have "trunks" - 2,3,4... interfaces there (active,
passive) - very easy! In your policies and routes you use only
configured trunks - very convinent. Do FGs have such functionality?
I had the same thing with my 300d on 5.2.10 firmwareSo I did firmware
restore through serial cable to 5.2.10 (5.6 did not start too). I thing
you should update your device to 5.4 first.
