Hi All, I have the following dilemma where the remote site is the same
IP range as the head office site.I am configuring SSL VPN to access from
the remote site. Is there away to configure without change the central
office IP range? I tried to follow ...
Good evening all, I have a configuration that I am not sure why it does
not work. This is Fortios 6.2.2 I attached the topology.Static route on
FTG is 10.10.1.0/24 to 10.10.1.25410.10.101.0/24 to
10.10.1.25410.10.102.0/24 to 10.10.1.254 VLAN90 - 10.1...
The issue is resolved I have to engage the Fortigate solution engineer.
Basically changed from physical switch vswitch interface to use physical
interface directly as I have all the rule and configuration configured.
Make sure to reboot the Fortigate...
Hi toshiesumi, I set the default gateway for the external is 0.0.0.0 to
wan1. From the switch, I can ping 8.8.8.8. When I put the client behind
the switch, I cannot ping the external. So I started the investigation.
I found that the pinging stop afte...
Hi Dave, I have configured vlan interfaces on the switch which I want to
remain the vlan interfaces there. VLAN 90interface vlan 90ip address
10.10.1.254 255.255.255.0 VLAN101interface vlan 101ip address
10.10.101.254 255.255.255.0 So on PC2 (101) - ...
I want to keep the intervlan on 3750 switch as this is the core switch
and we want to use Fortigate as a Firewall only. So the internal routing
is happening on the core switch. It is configure as ip routing which
then can route between the vlan inter...
Hello Silver, I am configuring one like you but I cannot make it work as
well. what is the Foritgate mode (interface or switch mode)? What is the
port configuration on the core which connect to Fortigate? For example -
I have a core switch port is G0...
