Hi, We're running a pair of 1000C's in A-P (v5.0,build3608 (GA Patch
7)). We currently manage both FW's using MGMT1 with one dedicated IP.
Does anyone how to give the primary and secondary separate dedicated
MGMT IP's ? I'd like to use MGMT 1 on Prim...
Hi, When I need to change the application sensor, IPS sensor or web
filter associated with a policy I need to drag the policy line right to
the bottom of the ruleset above the implicit deny, change the UTM sensor
or policy, then move back to the corr...
Hi, I need to remove uneeded configuration from my FG 1000c for audit
purposes. We do not use the wireless controller features so I would like
to remove the two section's below. I have tried to remove but get the
error's at the end of this post - i h...
Does anyone know how to do the equivalent of a " terminal length 0" on a
Fortigate firewall? Our Fortigate has roughly 65k lines of config in the
configuration file - hitting space bar all the way to the bottom is
painful.
Hi, Does anyone have an overall guideline or check-list for hardening a
1000c. The firewall is currently being used for web filtering and
application control, I will be adding some simple DLP sensors and IPS
also. pj
Thanks Jeff!!! il get a change scheduled and test this out. Jeff_FTNT
wrote:You may try enable "ha-magmt-status " on both Master and Slave,
set up different IP, you can manage Master and Slave with different
IP.Config sys haset ha-mgmt-status enable ...
Hi Dave, Cheers for the response, I usually run Chrome but just tried
with FF and IE, no joy, exactly the same issue...worth a shot though!!
Sounds like a bug to me. I also forgot to mention it happens if I amend
the policy in anyway - like remove or...
Dave Hall wrote:Go into "Systems->Config->Features" and turn off "Wifi &
Switch Controller". After that, you should be able to delete the
mesh.root interface. Hi Dave, I have disabled the WiFi and Switch
controller as suggested - unfortunately I stil...
