Hello,I am trying to set up automatic failover wan using link-monitor
and not SDWAN. Before I even get as far setting up the link-monitor I am
running into an issue. My primary is wan2 and backup is wan1. I have
tried setting the static route for the...
I have a FGT40F (behind NAT) at a remote office and a FGT61F at my home
office with an IPsec tunnel between them. Both were on 7.4.3 and all
good. I updated the 40F to 7.4.4 and now the IPsec VPN will not connect.
I rebooted both ends and tried to en...
I have a FGT61F running 7.4.3 at the home office and another identical
in a remote office. Home office has the static IP. We had a long-term
power outage over the weekend and once it was restored the tunnel will
not come back up. I have rebooted the ...
Toshi,Thank you! That was it. I disabled default gw and it now works as
expected. I also tried leaving it enabled and entering a higher distance
on the retrieve gw for the backup wan and that worked as well. Thanks
again for all of your help. Really ...
No change. No matter which one has the higher priority, it goes through
wan1 whenever it is connected.It shows wan2 with a * but I get public IP
from wan1 Routing table for VRF=0S* 0.0.0.0/0 [5/0] via 192.168.10.1,
wan2, [1/0] [5/0] via 192.168.21.1,...
Here it is. Weird thing is [both up, working on wan2] and [wan2
restored] look the same, but when [wan2 restored] and I go
whatismyipaddress.com I still see the wan1 IP.
Here it is. Weird thing is [both up, working on wan2] and [wan2
restored] look the same, but when [wan2 restored] and I go
whatismyipaddress.com I still see the wan1 IP. both up, working on
wan2Routing table for VRF=0S* 0.0.0.0/0 [5/0] via 192.168.10...
Here it is. Weird thing is [both up, working on wan2] and [wan2
restored] look the same, but when [wan2 restored] and I go
whatismyipaddress.com I still see the wan1 IP. both up, working on
wan2Routing table for VRF=0S* 0.0.0.0/0 [5/0] via 192.168.10...
