Troubleshooting Tip: Using the FortiOS built-in pa...

pkungatti_FTNT · 09-30-2024

Description This article describes how to troubleshoot the failure to connect to FortiGuard servers with the error: 'upd_comm_connect_fds[464]-Failed SSL connect'. Scope FortiGate. Solution FortiGuard communication with FortiGate is self-generated tr...

pkungatti_FTNT · 09-17-2024

Description This article describes how to disable firewall features on FortiGate and configure FortiGate as a Layer3 router. Scope FortiGate. Solution FortiGate is a stateful inspection firewall; by default, firewall features are enabled. FortiGate s...

pkungatti_FTNT · 09-08-2021

Description This article describes how to add the source Mail ID for the Automation trigger and Alert Mail.The requirement of adding the source Mail ID is some of the mail servers will not accept the mail if the source Mail ID is not properly set.For...

pkungatti_FTNT · 01-26-2021

DescriptionThe link control protocol (LCP) frames are transmitted during the link establishment and termination phases, and periodically during the life of the link. It is used to negotiate the configuration of the PPP link, and to test and maintain ...

pkungatti_FTNT · 11-27-2020

Description This article describes how to configure SOCKS (Socket Secure) in the explicit proxy. Scope FortiGate.Solution Execute the below commands to configure socks in explicit proxy: config web-proxy explicit set socks enable / disable set socks-...

pkungatti_FTNT · 11-22-2021

Dear JonasYour issue required to verify configuration and do deeper troubleshooting. I would suggest to raise a ticket with Fortinet technical support. Visit us at https://community.fortinet.com to get answers to questions, technical documentation, a...

User Statistics

User Activity

Troubleshooting Tip: Fail to connect to FortiGuard servers with the error 'Failed SSL connect'

Technical Tip: How to configure FortiGate as a Layer 3 router

Technical Tip: How to set Source Mail for Automation Trigger and Alert Mail

Technical Tip: How to modify the LCP Echo timer in L2TP VPN

Technical Tip: Configure SOCKS in explicit Web proxy

Re: L3 VLAN interface up, but IP/Network missing under locally connected network

Troubleshooting Tip: Using the FortiOS built-in pa...

Technical Note: Routing Change and Session Fail-ov...

Technical Tip: How to configure FortiGate as a Lay...

Fortinet Training Institute

KCS