Hi guys, We have a Fortigate 90D we use for a test environment. When I
tried to access the Web GUI recently I found that after you enter
credentials it would either have or give a HTTP 500 error. Accessing via
SSH worked OK until I tried to format th...
Just thought I'd post this here for others who have the same issue in
future. According to Fortinet support there is a bug in firmware 5.2.2
that causes the "ALL" service group to be ignored, so any policy rules
that use it will be ignored. It is fix...
Hi guys, I've done a search and come across a few answers but wonder if
anything has changed in the later versions of FortiOS to make this
simpler. Suppose we have two servers on the internal-side of a Fortigate
(in some cases on the same interface, ...
Hi guys, We' ve looked through the documentation but cannot seem to get
a definitive answer on this, any input would be great! Fortigate 100D on
FortiOS 5.0. We' d like to load-balance HTTPS across two servers however
when configuring the Virtual Ser...
Hi guys, I' m setting up a 100D with three VDOMs; a root and two
customer VDOMs. On the WAN side the 100D is connected to the ISP switch.
The ISP typically issues you a subnet to be used for your firewall WAN
interface(s) then you can register additi...
I finally got out to the site to take a look. I formatted the disk over
the serial management port and TFTP'd a later firmware onto it, but
after it booted up (very slowly) it got to the login prompt and quite
quickly started throwing EXT3 disk error...
I know this is a very old thread, but I got caught with this issue again
last week and just wanted provide some more info for future travelers,
maybe save an hour or two :). The firewall in-question here has
subsequently been upgraded through various...
OK so the problem we had upgrading from 5.0.x to 5.2.x turned out to be
an issue with the boot partition. We were able to upgrade one 100D no
problem, the other wouldn't boot when upgraded. On Fortinet's advice we
formatted the boot partition then tr...
FWIW I also had the boot loop when upgrading a 100D to 5.2.2. Tried from
5.0.0Patch1 all the way through 5.0.0Patch11, same thing, it wouldn't
boot. I certainly would not be upgrading to 5.2.2 remotely as things
stand! Also tried going from 5.0.11 to...
Enrico I'd agree with Dave, for a case like that you'd probably be
better off with split-DNS assuming you control the DNS server these
users use when they are in the office. This isn't an option for our case
due to there being a large number of serve...
