Hi, we have Fortigate 60E.Last two months we have problem with
unexpected breaking of 60E operation.It breaks all traffic for few
minutes and after that it starts operating (no admin action is
required). We have small office with up to 15 PCs and up ...
If WAN2 goes down, WAN2's GW ping is not accessible (from intranet).
From the Internet is not accessible our public IP which is set on WAN2.
I've already tried to disable ping or set it to 10, no change. I think
it could be caused by our ISP. For the...
I set Estimated Bandwidth, but nothing changed.Static Route is set for
interface SD-WAN and Dynamic Gateway is enabled. Routing monitor shows
correct settings.I can not monitor the main ISP, I only ping to it.I
have enabled a bandwidth history graph ...
The ISPs are under SD-WAN. The main is 20Mbit line. When it is down,
then 5Mbit line is switched (and back).There is no error in diag
commands (wan1 is 5Mbit, wan2 20Mbit). We used the second ISP because of
the main line was often down.When 5Mbit is ...
You are leaving our website
You are leaving our site and we cannot be held responsible for the content of external websites
