Hello, Having issues keeping a VPN Site-to-Site tunnel up.. My devices
are a FG100D and the remote device is a FG30, both have been updated to
v5.2.3 firmware. I set up the site-to-site with the VPN wizard, the VPN
tunnel was working for about 3 days...
Still having the issue on my end. Changed PHASE 2 back to all zeroes
since it did not have any effect and emonoc mentioned it should not have
any relevance. @emonoc - I made the changes back to all zeroes. Added
the kelifeseconds and the keylife-type...
UPDATE: Uptime was about 5 days, the tunnel went down. Rebooted the 30D
and the tunnel came back up. Co-worker said he read a post about a
similar issue to mine. The fix was to update the Phase 2 section of the
tunnel with the correct local and remot...
All of these steps were done on both sides. - I changed the tunnel from
a Wizard created Tunnel to a Custom Tunnel.- In Authentication, changed
the IKE to V2..- In Phase 1 - Setup different Diffie-Hellman groups than
the default (make sure it matches...
You are leaving our website
You are leaving our site and we cannot be held responsible for the content of external websites
